Twin screw extruder machine maintenance guide

Writer： admin Time：2019-12-28 14:40 Browse：℃

Once you bought extruder machine, you need pay more attention to the maintenance. A good and right maintenance process is conducive to extending the machine life. In this article, we will learn how to maintenance the machine.

1. After 500 hours of use, there will be scraps of iron or other impurities worn down by gears in the reducer. Therefore, the gears should be cleaned and the lubricating oil of the reducer should be replaced at the same time.

2. After a period of time, a comprehensive inspection of the extruder should be carried out to check the tightness of all the screws.

3. If there is a sudden power cut in production and the main drive and heating stop, when the power supply is restored, the sections of the barrel must be reheated to the prescribed temperature and kept warm for a period of time before the extruder can be started.

4. If the turning fullness of the instrument and pointer is found, the contact of the thermocouple and other sidelines should be checked.